U1798 Oldsmobile Ninety-eight Engine Fault Code

Check Solution For U1798 Oldsmobile Ninety-eight OBD Code :

U1798 Oldsmobile Ninety-eight engine code seems a kind of network problem, we try to show one by one the meaning and the solution.
Brief explanation of the U1798 Oldsmobile Ninety-eight code and definition of U1798 Oldsmobile Ninety-eight is the bottom side.

U1798 Oldsmobile Ninety-eight Meaning :

u Network Code
Problem is climate control system, lighting, airbags, etc.
1 MFG - Manufacturer Specific
7 Auxiliary Emission Controls
9 Crankshaft Position Sensor Circuit Performance
8 PCM Stack Overrun

MFG - Manufacturer Specific codes, which have a '1' as their second digit to indicate they are unique to a particular vehicle make or model. These special codes were deemed necessary by the vehicle manufacturers so they could provide additional diagnostic information beyond the basic list of generic OBD II codes for all kinds of faults, not just emissions-related faults.

How To Fix U1798 Oldsmobile Ninety-eight ?

Regarding the U1798 code, it would probably be worthwhile to carefully inspect the wire harness near the intake manifold bracket. This is done most easily from below the car in the area near the oil filter.

U1798 Oldsmobile Ninety-eight Code Description:

While fuel economy was increased, acceleration was seriously compromised, and the loss of engine vacuum led to a dangerous loss of braking assist when the U1798 code system was in four-cylinder mode. In addition to these issues, while the company proposed a hydraulically controlled system that could be switched from within the car, the version they implemented had to be manually changed in the engine compartment using hand tools. When you see U1798 Oldsmobile Ninety-eight engine fault code on your engine code reader this description will help you.

U Codes List of all Network codes.

Final Step: In the definitions listed below, there is a test drive recommended after you've completed any repairs to see if the condition is fixed. Before you take a test drive after a repair, always erase the U Code(s) first. This will turn the check engine light off and then you will know if the check engine light returns, you've got further diagnostics to complete.

BE CAREFUL !
This engine code information is presented for information purposes only. This is not intended as repair advice and we are not responsible for any actions you take on any vehicle.

About Us | Contact | Privacy

Copyright © 2016 - EngineFaultCode.com
All rights reserved.
Sitemap

Valid CSS!